Evaporators & Accessories

A replacement brass valve for a sight gauge. This is just the valve that comes with the rubber gasket inside. The valve has 1/2" male threads on it...

Sap Level Gauge Gasket.

Brass Washer for Sap Level Valve.

Most producers that have tried an automatic drawoff could not imagine boiling without one again. This is a full feature Max Marcland automatic draw...

H2O 2" Modulating Automatic Draw-off with Barometric Compensation, Motorized Valve, Controller and Probe. Comes with the down spout. Has a 2" tri-c...

This is a spare/replacement temperature probe for an automatic drawoff. A spare probe can make changing drawoff sides much easier. Just change the ...

V11 - 1" Motorized Stainless Ball Valve only. This is a spare valve for use with a Marcland Max or Mini Automatic drawoff.

A rubber plunger for the inside of the Solenoid valves. This little rubber piece is what forms the seal inside the solenoid valve.

This bracket is made to hang on the side of a Leader welded flue pan and then you can mount your Marcland control box right on it. The bracket fits...

Thermometer Bracket for Welded Pan (for digital or dial therm.)

Temp. Probe Clip for Marcland Auto Drawoff temperature probe. This clip gets attached to the pan with a bolt (not included) and then the temperatur...

A digital meter that tells you the barometric pressure in inches of mercury and the boiling point of water in degrees of Fahrenheit based on the ba...

Bolt-On Regulating System with Float.For use with all welded Half Pint and Supreme BoilingPans.

A replacement float for a Grimm or Leader hot sap float. This float measures 8.5" x 4.5". They now are making them with a crank on the top which al...

This stainless welded float is used for the flue pan for many of new Leader evaporators. It measures 5 1/2" wide and is 10 3/4" long. It has a cran...

A stainless welded float that is 5" wide and 8.5" long. This float is for the syrup pan on a Small Brothers evaporator. It has a hole on each side ...

A stainless welded float that is 6 1/8" wide and 12" long. This float is for the flue pan on a Small Brothers evaporator. It has a hole on each sid...

A rubber washer that is used in the pan connections between the flue pan and the syrup pan on a Grimm raised flue evaporator or a Leader Patriot.

A stainless washer that is used on the pan connections between the flue pan and the syrup pan on a Grimm raised flue evaporator or a Leader Patriot...

A 2 3/8" rubber washer for a Grimm evaporator.

A 2 3/8" Metal washer for a Grimm evaporator.

This is the rubber regulator packing used in a Z arm for a Grimm evaporator or the older Leader Patriot evaporators. This packing was used for the ...

This thin rubber packing is used for the cold sap regulator on many of the Leader and Grimm evaporators. Leader has also started using it on the re...

This regulator packing is a soft material almost like a foam. It is 3/16" thick and 1 3/4" in diameter. It is used on many of the old Small Brother...