Products

Sap Level Gauge Gasket.

A replacement 1/2" diameter glass tube that is 12" long for a standard sight gauge.

0°-10° Brix

Sap Sak. Holds 2.5+/- Gallons.

Sap Sak Holder

This brush has a long handle and is perfect for cleaning down in between the flues on a flue pan. Whether it is a raised flue or a drop flue, this ...

This sight gauge is for the flue pan, and comes with a 1/2" brass gate valve, 18" glass tube, and a stainless bracket to hold the top of the tube. ...

A replacement brass valve for a sight gauge. This is just the valve that comes with the rubber gasket inside. The valve has 1/2" male threads on it...

A triangled shaped brush designed to get down in between the flues on the back pan. Works with raised or drop flues. 10" from the handle to the bot...

SB 1 1/2" Aluminum Yoke for Hot Sap Regulator

Screw for CDL Multi Fittings

2" in diameter; 8" tall for use with the Short Syrup Hydrometer

Brix scale. 1°-12°Brix calibrated at 38°F State of Vermont inspected Hydrometers are fragile, glass instruments. They must be handled very cautious...

Baume & Brix scale 25°-40° Baume, 45°-75° Brix. Red lines at hot and cold test. 9 3/8" long - can be used with any of our hydrometer cups, but ...

Sight Level for Mainline

A long handled nylon brush designed to clean the glass sight tubes on evaporators. From the tip of the brush to the end of the handle it measures 24".

Silver Foil Capsules. Sold individually. A silver foil that fits over the cover on a 24mm and 28mm bottle. This foil is pressed on and manually mol...

Fits 3/4", 1", and 1 1/4" mainline pipe; requires 31/64" hole

Single Manifold Saddle w/Elbow - While Supply Lasts

This regulator packing is a soft material almost like a foam. It is 3/16" thick and 1 3/4" in diameter. It is used on many of the old Small Brother...

A hot sap regulator for a Small Brothers evaporator. The yoke goes over the elbow and hangs on the 1" feed pipe to the front pan. There is a piece ...

This is the cold sap regulator for many of the old Small Brothers evaporators where the feed was coming in from the bottom. The bottom of this item...

Small Brothers Flue Pan Regulator Arm

A stainless welded float that is 6 1/8" wide and 12" long. This float is for the flue pan on a Small Brothers evaporator. It has a hole on each sid...

A stainless welded float that is 5" wide and 8.5" long. This float is for the syrup pan on a Small Brothers evaporator. It has a hole on each side ...

Protect your bucket with this small flat galvanized bucket cover. Eliminate the contamination and the dirt accumulation in your bucket. Size measur...

Small Gold Elastic Tie 50/pkg

Small Homemade Stainless Round Draw-off Tank w/Valve (10 1/2" diameter x 20" high).

Small Maple Leaf w/Hook (metal)

A small bunny shaped candy mold. Each of the 20 cavities has a little bunny that looks like it is ready to hop away. The cavities measure 1" long a...

Small Sap Regulator Bridge.

The difference between a large scoop and a small scoop is just the width of the scoop. A large scoop is about 5.5" wide, but this small scoop is on...

Small Stainless Skimmer

Small Wire Puller

Smart Trek Smart Station (Gateway, tablet, tank level and single port sensor). H2O-Smartrek Monitoring SystemThe H2O-Smartrek system is a highly ef...

Smart Trek Starter Kit (Gateway and tablet). H2O-Smartrek Monitoring SystemThe H2O-Smartrek system is a highly efficient solution providing accurat...

Smart Trek Vacuum Sensor - Double Port. H2O-Smartrek Monitoring SystemThe H2O-Smartrek system is a highly efficient solution providing accurate int...

Smart Trek Vacuum Sensor - Single Port. H2O-Smartrek Monitoring SystemThe H2O-Smartrek system is a highly efficient solution providing accurate int...

Smart Trek Vacuum Sensor - Three Ports

Smiley Face Plastic Sucker Mold

Smoke Stack Thermometer

Snap Clip for Vacuum Releasers.

No two snowflakes are alike, unless you get this candy mold. It has 20 cavities and while many of the snowflakes are different there are a few repe...

A rubber candy mold of snowmen. Each mold has 16 cavities and each cavity is of a snowman with a pipe and holding a broom. They measure 1 1/8" wide...

All new containers come with caps. Gold cover that is solid on the top (no holes) that fits the older 1 pound honey jars with a wider top (roughly ...

Spout Driver for use with the Stainless Bucket Spout (#SPGS).

Spout Plug Soft